Les cookies nous permettent d'offrir nos services. En utilisant nos services, vous acceptez notre utilisation des cookies.
Interrupteur temporisateur SMD universel, relais temporisé 0,3–480 sec, kit 10A, retard OFF, 12V
Characteristics:
Accuracy: 0.3 to 480 seconds
Relay exit:
20A/24V DC
20A/12V DC
Nutrition:
Voltage: 12V DC
Red thread: +
Fil noir : -
Protection: Includes protection against reverse polarity of the power supply
Réglage du temps :
Adjustable via a trimmer
Tour the anticlockwise senses to increase the delay times
Exit:
Deux fils blancs – contact Normal Overt (NO)
Function principle:
When the power supply is active, the relay is set in March and the contact NO (the two white wires) is stopped, maintenant this position just at the end of the regular time. Couper et rétablir l'alimentation redémarre le cycle.
Description physique :
The item is not stored in a plastic box; This is four of the plaque forms, as shown in the image.
The timer is assembled and just now.
Schéma de câblage :
Nutrition:
Connect the mains wire to the 12V+ source (e.g. positive borne of the current battery).
Connect the black wire to the 12V source (ex. borne negative of the current battery).
Connexion de sortie :
Connect the two white wires to the charge that you can then check via contact NO.
Instructions for use:
Retard time setting: Adjust the trimmer with a short rotation. Tour the anticlockwise senses to increase the delay times.
Put under tension: When the power supply is switched off, the relay is active and the contact is NOT stopped, allowing it to immediately pass through the charge.
Be careful of deactivation: After the expiration of the normal time, the relay returns to its initial state and the contact NO is switched on, interrupting the current flow through the charge.
Redémarrage du cycle: Pour redémarrer le cycle, coupez et rétablissez l'alimentation.
Conseils de sécurité :
Make sure that all connections are secured to avoid court circuits or bad connections.
Check that the charge does not exceed the nominal capacity of the relay (20A) to avoid all damage.
Check the polarity of the power supply to effectively use the protection function against voltage inversion.
In accordance with these instructions, you can effectively use the time relay to activate different charges at different times, telling you what the lights or other devices are, guaranteeing reliable and tested performances.
Deselectra Electronics